Products Home Page > Car

 
LCU-ONE Wide Band Lambda Controller. Full control of your engine
LCU-ONE Lambda controller range of products allows you to perfectly tune the carburetion of your engine to keep it at peak performance.
 

 

LCU-ONE

LCU-ONE uses a wide band Bosch LSU 4.9 probe and can detect an accurate Lambda value from 0.65 to 1.6, offering you an extremely precise measurement, essential for engine tuning.

Through the analysis of the remaining oxygen in the exhaust, LCU-ONE illustrates possible oxygen excess/deficit in the carburetion, providing essential information for engine tuning. The LCU-ONE is able to be configured to be used on petrol, diesel or ethanol powered engines.

Extremely small sized and lightweight, all LCU-ONEs are waterproof.

Versions

The LCU-ONE range is available in three different versions:

LCU-ONE CAN: uses a CAN bus and is extremely easy to install. Switches on/off with the logger. Perfect for use with an MXL, MyChron4, or EVO3 and EVO4 loggers.

LCU-ONE Analog: uses a serial line for programming and an analog output proportional to lambda value. Switches on/off with the logger.

LCU-ONE CAN+Analog is equipped with both CAN bus and analog output.
 
Features
All products are Waterproof IP67 and small sized (80 x 37 x 15 mm).
LCU-ONE CAN
 
  • CAN connection
The product configures Stoichiometric point and provides:
 
  • Lambda value and Air/Fuel ratio
 
  • Lambda probe temperature and diagnosis
LCU-ONE Analog
The product provides Lambda value and Air/Fuel ratio and - thanks to the dedicated Lambda Configurator software, LCU-ONE Analog allows to configure:
 
  • Stoichiometric point
 
  • Analog output (0-5 Volt)
 
The product configures:
 
  • CAN connection+ Analog output
 
  • Stoichiometric point
LCU-ONE CAN+Analog also provides:
 
  • Lambda value and Air/Fuel ratio
 
  • Lambda probe temperature and diagnosis
 

 

 

 
COPYRIGHT DATASPARES ACQUISITION LIMITED 2008© TEL +44 (0)208 4639222 | FAX +44 (0)208 4639333