| Wire colours |
|
Output |
| White or yellow |
signal |
0 bar = 0.5 volts |
| Red |
12 volts |
7 bar = 4.5 volts ( linear ) |
| Black or blue |
0 volts |
|
Please note : Aim wiring harnesses, MXL Pista and EVo3 – not all channels have a 12 volt supply wired to them! Generally channels 5, 6, 7 and 8 have a 12 volt supply so connect your pressure sensor to one of these.
Calibration for AIM Race Studio 2
Select your logger type from the buttons at the side
Logger Manager
General Window
Select the configuration you want
Channels Window
Select any channel that is free (suggest 5,6 7, or 8 as per wiring note above )
Give it a name (eg fuel pressure)
Sampling rate 10Hz (recommended)
Click on Customise Sensor
Customise Sensor Window
| X |
(mV) |
Y |
| 1 |
500 |
0 |
| 2 |
4500 |
7 |
Compute Curve
| Sensor Name |
Dataspares 7 bar (recommended) |
| Sensor Unit |
bar |
| Sensor Type |
other type |
Save Sensor (the sensor should now appear in the box above)
Exit
Channels Window
Select Dataspares 0-7bar from the pull down menu
Upper boundary 7 (recommended)
|
