NOTE: Before calibrating ensure
potentiometer is centred correctly
(grub screw inline with wire)
Select your
logger from the buttons at the side
Logger Manager
General Window
Select the logger you want
Channels Window
Select any channel that is free
NOTE – Formula Renualt Users can only
choose Channels 4 - 8
Give it a
name (eg steering)
Sampling rate
20Hz (recommended)
Select
Mid Zero Potentiometer from the pull
down menu
Lower Bounce-180 (recommended)
Upper Bounce180 (recommended)
Click on the
Transmit button
Calibration Window
Click on the blue
Calibrate button next to the channel
you have selected for steering
Sensor Calibration Window
Follow the instructions
below:
Turn steering
wheel 90degrees to the right
Click
Get Raw Value button
Turn steering
wheel to 0 degrees
Click
Get Raw Value button
Turn steering
wheel 90degrees to left
Click
Get Raw Value button
Enter the
value 90 for HIGH POSITION
Enter the
value -90 for LOW POSITION
If you are
not sure if was done right you can watch measure box for actual angle
If any values
are incorrect set the steering wheel to position and click
Get Raw Value button again
If correct click
OK
Calibration Window
The status of the steering
channel should now read Calibrated in
red
Click on the
Transmit Calibration button to send
to the logger
Technical
Specifications
| Wiring Code
– binder 719 & 712 |
| White |
signal |
1 |
| Black |
0V |
3 |
| Red |
5V |
4 |
| Wiring Code for
Mychron3 gold & plus |
| Brown |
+vref |
pin G or K |
| Black |
0V |
pin B, D, F or
J |
| White |
signal |
pin A, C, E or
H |
| Wiring Code for
ST1 |
| Brown |
+vref |
pin D or V |
| Black |
0V |
pin S, T, U or
F |
| White |
signal |
pin A, B, C or
E |
