Select your logger from the buttons at the side
Logger Manager
General Window
Select the logger you want
Channels Window
Select any channel
that is free
NOTE – Formula Renault Users should use
Channel 1
Give it a name (eg throttle)
Sampling rate 10Hz (recommended)
Select Zero Based Potentiometer from the pull
down menu
| Lower Bounce |
-5 (recommended) |
| Upper Bounce |
105 (recommended) |
Click on the
Transmit button
Calibration Window
Click on the blue
Calibrate button next to the channel you have selected for throttle
Sensor Calibration Window
Follow the
instructions shown
Fully open the throttle and click on the Get Raw
Value button
Release the throttle and click on the Get Raw
Value button
Enter 100 as HIGH POSITION value
Click OK
Calibration Window
The status of the
throttle channel should now read Calibrated in red
Click on the
Transmit Calibration button to send to the logger
Technical Specifications
| Wiring Code
– binder 719 & 712 |
| Red |
5V |
4 |
| Black |
0V |
2 |
| White |
Signal |
1 |
| Wiring Code for
Mychron3 gold & plus |
| Brown |
+ Vref |
pin G or K |
| Black |
0V |
pin B, D, F or
J |
| White |
Signal |
pin A, C, E or
H |
| Wiring Code for
ST1 |
| Brown |
+ Vref |
pin D or V |
| Black |
0V |
pin S, T,U or F |
| White |
Signal |
oin A, B, C or
E |
